Page 1 of 1

Can't get into settings, YDL 6.2, I removed the module

PostPosted: 08 Jun 2012, 05:36
by RoboFlop
Can't get into settings, YDL 6.2, I removed the module

Oops. Newbie mistake...

I've installed YDL 6.2 on a Powerbook G3 Pismo. While in the settings, I removed some modules, like a "bar" module. I didn't realize, one of those modules was the obvious way to open the settings panel. Now I can't figure out how to load settings, apps or the shutdown functions that used to be at the top of the screen.

Is there a way to get back into the settings, or, is there another way to reload the modules?