# Script source:  http://advantedgecomputing.com/opensource/gc83linux.html
# Assembled by Riyan Mynuddin - e-mail: opensource@advantedgecomputing.com
# Feel free to e-mail Riyan with questions, comments or suggestions.
# 
SAY 'Starting GPRS connect script...\n'
SAY '\n'
# ispauth CHAP		# define auth method (optional)

SAY 'Setting the abort string\n'
SAY '\n'

# Abort String ---------------------------------

#ABORT BUSY ABORT 'NO CARRIER' ABORT VOICE ABORT 'NO DIALTONE' 
ABORT 'NO DIAL TONE' ABORT 'NO ANSWER' ABORT DELAYED
#TIMEOUT 10
#ABORT 'BUSY' ABORT 'NO ANSWER' ABORT 'NO CARRIER'

# ----------------------------------------------
SAY 'Initializing modem\n'

# Modem Initialization -------------------------
#'' ATZ
# Eo=No echo, V1=English result codes
#OK     'ATE0V1'
'' AT+cfun=1		
OK AT+cfun=1		
OK AT+cgreg=1
OK AT
#TIMEOUT 40
# ----------------------------------------------

# Additional initialization (optional) ---------
# /begin att
OK AT&F&D2&C1E0V1S0=0
OK AT+IFC=2,2
OK ATS0=0
OK AT
OK AT&F&D2&C1E0V1S0=0
OK AT+IFC=2,2	
# /end att
#AT&FE0S0=0
#AT&F0&D2+IFC=2,2V1Q0XIS0=0S7=50+CMEE=1

# ----------------------------------------------

SAY '\n'
SAY     'Setting APN\n'

# Set Access Point Name (APN) ------------------
# Incorrect APN or CGDCONT variable is a
# frequent cause of peer LCP TermReqs
# So try each setting at least once! =)

#REG:\s1 AT+cgdcont=1,"IP","proxy"
#OK     'AT+CGDCONT=0,"IP","proxy"'
#OK     'AT+CGDCONT=1,"IP","proxy"'
#OK     'AT+CGDCONT=2,"IP","proxy"'
#OK     'AT+CGDCONT=0,"IP","isp.cingular"'
OK     'AT+CGDCONT=1,"IP","isp.cingular"'
#OK     'AT+CGDCONT=2,"IP","isp.cingular"' <-- mod'd

# ----------------------------------------------


SAY '\n'
SAY     'Dialing...\n'
# Dial the ISP ---------------------------------
# a few different dial commands are shown
# the default should work fine

#REG:\s1 'ATD*99***1#'
OK      ATDT*99***1#	
#OK      ATD*99***1#	
#OK	ATD*99#		
#OK     'ATD*##***##'
#OK
CONNECT ' '

# ---------------------------------------------